Kenwood KMM-BT332 Manual De Instrucciones página 41

Troubleshooting
Symptom
"CODE ERROR"
"NO CONTENT"
"SCAN CANCEL"
No Bluetooth device is • Search from the Bluetooth device again.
detected. • Reset the unit. (Page 4)
Bluetooth pairing cannot • Make sure you have entered the same PIN code to both
be made.
• Delete pairing information from both the unit and
Echo or noise is heard during • Adjust the microphone unit's position. (Page 16)
a phone conversation. • Check the [ECHO CANCEL] setting. (Page 18)
Phone sound quality is poor. • Reduce the distance between the unit and the Bluetooth
• Move the car to a place where you can get a better signal
Phone call sound cannot be • Press 6 IW during a call to switch between hands-free
heard from the car speakers.
Voice calling method is not • Use voice calling method in a more quiet environment.
successful. • Reduce the distance from the microphone when you
• Make sure the same voice as the registered voice tag is
Remedy
Make sure you have entered the correct pass code.
(Page 14)
There is insufficient content to start TuneScan.
TuneScan has been aborted.
the unit and Bluetooth device.
the Bluetooth device, then perform pairing again.
(Page 17)
device.
reception.
and private talk mode. (Page 18)
speak the name.
used.
Symptom Remedy
Sound is being interrupted or • Reduce the distance between the unit and the Bluetooth
skipped during playback of a audio player.
Bluetooth audio player. • Turn off, then turn on the unit and try to connect again.
• Other Bluetooth devices might be trying to connect to the
unit.
The connected Bluetooth • Check whether the connected Bluetooth audio player
audio player cannot be supports Audio/Video Remote Control Profile (AVRCP).
controlled. (Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
"NOT SUPPORT" The connected phone does not support Voice Recognition
feature or phonebook transfer.
"NO ENTRY" There is no registered device connected/found via
Bluetooth.
"ERROR" Try the operation again. If "ERROR" appears again, check
if the device supports the function you have tried.
"NO INFO"/"NO DATA" Bluetooth device cannot get the contact information.
"HF ERROR XX"/ Reset the unit and try the operation again. If this does not
"BT ERROR" solve the problem, consult your nearest service center.
"SWITCHING NG" The connected phones might not support phone
switching feature.
The Bluetooth connection Delete the unused registered Bluetooth device from the
between the Bluetooth unit. (Page 20)
device and the unit is
unstable.
35
ENGLISH