Cleaning And Maintenance - MSW Motor Technics MSW-SPS-18 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 51
CAUTION! Do NOT install the bearing with a damaged retaining ring.
a) Fit a silver shield pair (8) to the hub flange. Assemble the shield pair (8) with
the screws (3).
b) Install the studs (2) in the pressure plate (1). Fit the pressure plate adapter
(6) into the center hole of the pressure plate (1).
c)
Slide the main screw (9) into the hole of the pressure plate adapter (6).
d) Lubricate the main screw (9).
e) Slide the other end of the main screw (9) into the bearing hole. Insert the
dowels (6) installed in the pressure plate (1) into the holes in the hub flange so
that they flush with the cover pair (7).
f)
Slide the bearing and the assembled tool elements into the hub holder. Make
sure that the bearing is seated perpendicular to the hub boss before mounting.
g) Position the silver colored pressure piece (4) on the main screw (9) so that it
rests against the outer edge on the back of the hub holder.
h) Thread the nut (10) onto the main screw (1) so that it rests against the pressure
piece (4).
i)
Grip the nut (10) and head of the main screw (9) with a suitable wrench. Slide
the bearing into the hub boss by turning the head of the main stud.
j)
When the bearing is correctly mounted, the retaining ring engages in the
retaining groove.

3.3. Cleaning and maintenance

a)
Use only non-corrosive cleaning agents for cleaning the surfaces.

Publicidad

Tabla de contenido
loading

Tabla de contenido