Cleaning And Maintenance - MSW Motor Technics MSW-DFV-100 Manual De Instrucciones

The vice is operated with the attached movable thrust lever - by turning it
clockwise, the jaws are brought closer to each other, while turning it in the
opposite direction causes the jaws to move away from each other. The
movement of the jaws is limited by the length of the screw on which they move
(see technical parameters for the given model). The vice has jaws/clamping
adapted to both flat and rounded elements (except for MSW-DFSV-150).
Furthermore, the MSW-DFSV-150 model has the capability of 360
around its axis. To rotate it in a given direction, release the rotation lock lever (F)
and rotate the vice to a given position, and then lock it in this position by
tightening the locking lever (F) again.
CAUTION: in order to ensure long and problem free operation of the device, the
fixed element should be located in the middle of the jaws, if possible.
3.4.

Cleaning and maintenance

a) Use only non-corrosive agents for cleaning the surface.
b) Do not spray the device with a stream of water and do not immerse it in water.
c) Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or metal
scraper) as these may damage the surface of the device.
d) After intensive work or in the event of frequent use, both the thread of the
feed screw and the guide should be lubricated or oiled with thick oil to
ensure smooth operation of the product.
DISPOSAL OF USED DEVICES
At the end of its service life, this product must not be disposed of with normal
household waste, but should be taken to a collection point for the recycling of
electrical and electronic devices. This is shown by the symbol placed on the
product, operating manual or the packaging. The materials used in the device
can be reused according to their intended use. By reusing materials or
conducting other forms of using used devices, you make a significant
contribution to the protection of our environment.
Local administration will provide you with information about the appropriate
point for disposal of used devices.
o rotation