Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY OF PRODUCT
Installation Template
10
ASSEMBLY OF PRODUCT
10.1
Installation Template
Drilling the Hanger Holes
Fig. 9
Fig. 10
2
Fig. 11
20
Paste the installing template provided within the product on the
surface where the product is to be installed.
Make holes with Ø4 mm diameter on the points marked as A, B, C,
D on the installing template (Fig. 9).
Drill the flue outlet hole specified in the installing template in the
sizes given.
The appliance should be mounted on the cabinet on the points A,
B, C, D by using 4 x 40 screws provided with the appliance. The
front panel should not be rubbed against the cabinet cover when
the sliding set moves (Fig. 10).
Place the plastic flue provided with the appliance on the flue outlet
1
on the appliance. Rotate the plastic flue clockwise (Fig. 11).
The sizes shown is the illustration is for represen-
tation purposes. Take the installing template pro-
vided in the product you have purchased into
attention.
ENGLISH
20.11.2018
Publicidad
Tabla de contenido
