Before The First Use - Princess Smart Infrared Panel Heater 350 Manual De Usuario

Instruction manual

BEFORE THE FIRST USE

• Put the power cable into the socket. (Note: Make sure the
voltage which is indicated on the device matches the local voltage
before connecting the device. Voltage 220V-240V 50-60Hz)
• When the device is turned on for the first time, a slight odour will
occur. This is normal, ensure adequate ventilation. This fragrance
is only temporary and will disappear soon.
• During heating up and cooling down there may be some noises
caused by the heater casing expanding and contracting, this is
normal and does not indicate any fault.
TOUCH BUTTON/DISPLAY FUNCTIONS
USE
• Push the on/off switch on the side of the heater to turn the heater
completely on or off.
Touch button functions
• Press the on/off touch button to turn the heater on, pressing it
again will set the device into stand-by mode.
6
• Wi-Fi button, when device is on or in stand-by mode:
– Press and hold for 6 seconds to put the heating into paring
mode (will beep 3 times).
– Follow the instructions on your phone.
• Press 'temperature up (+)' or 'temperature down (-)' buttons to
regulate the temperature you desired. The temperature can be
set between 0°C and 37°C. Holding the + or – button will increase
or decrease target temperature continuously.
• Timer button; when the device is on, press the timer button, the
time starts blinking "00:00".
– Use the + and – buttons to set the hours.
– No button press for 5 seconds stops the time blinking.
– Setting time to 00:00 does not enable timer.
– Press timer button again -> time starts blinking and allows the
user to change timer duration.
– The remaining time is visible at the display.
– After the set time has expired the device will power off.
– Long-press while timer is running cancels the timer mode.
• Indicator lamp;
– On when heating element is on.
– Off when heating element is off.
Display
• When the red on/off switch is off, the display screen is also off.
• When power is on (on/off switch is on), and the machine is in
stand-by mode, the display screen is off, only when the device is
already connected to Wi-Fi, the display screen is off with only the
Wi-Fi icon visible.