Before The First Use - Princess Smart Glass Panel Heater 01.341500.01.001 Manual De Usuario

Wall mounting
• Please note that the product must be installed at least 15 cm
from the floor and 50 cm from the ceiling.
• First install the bracket with the provided screws. (image 1)
• Drill the holes in the wall on each side, then insert the plastic
expanded plugs and fix the bracket in the wall with the screws
provided. (image 2)
• Place the heater in a suitable position and ensure that the holes
are aligned with the bracket. (image 3)
• Tighten the screws on top of the bracket. (image 4)

BEFORE THE FIRST USE

• Place the device on a flat stable surface and ensure a minimum
of 10cm free space around the device. This device is not suitable
for installation in a cabinet or for outside use.
• Put the power cable into the socket. (Note: Make sure the
voltage which is indicated on the device matches the
local voltage before connecting the device. Voltage 220V-240V
50/60Hz)
• When the device is turned on for the first time, a slight odour will
occur. This is normal, ensure adequate ventilation. This fragrance
is only temporary and will disappear soon.
• During heating up and cooling down there may be some noises
caused by the heater casing expanding and contracting, this is
normal and does not indicate any fault.
Instruction manual
EN
5