Switch On/Off - T'nB CBHOME Instrucciones

EN
PAIRING:
Make sure the headset is off before pairing
Press the «ON» button until the indicator light starts flashing blue
Turn on the Bluetooth function of your TV, phone, or other Bluetooth device
Search for the Bluetooth device «TNB CBHOME» in the list of Bluetooth devices
available.
If pairing has worked, a blue indicator light will light up.
If pairing did not work, turn off the headset and try pairing again.

SWITCH ON/OFF

To turn on: Press the «ON» button for 3 seconds until the blue indicator light
is on.
To turn off: Press the ON button for 3 seconds until a red indicator light turns on
and then turns off.
TAKE A CALL
Your phone must be located at a maximum of 1m away
To answer a call: press the Play / pause / take a call button
To hang up: press the Play / pause / answer a call button
To reject the call: press the Play / pause / take a call button for 3 seconds
LISTEN TO MUSIC
BLUETOOTH MODE
To listen to music with your wireless home headset, make sure it is paired with
a Bluetooth device. If you are using your headset for the first time, refer to the
«Pairing the headset» section of this manual
WIRE MODE
Connect your device to the headset using a 3.5mm jack cable, then listen to
your music.
MICRO SD MODE
Insert a micro SD card into the memory card slot and press Play
TRACK CONTROL
Press the + button to move to the next track
Press the - button to review the previous track
VOLUME CONTROL
Press the + button to increase the volume
Press the - button to reduce the volume.
RECALL THE LAST NUMBER
Press Play twice when the headset is in standby, to call back the last number in
your call list.