Philips SBCRU125 Manual De Instrucciones página 4

All manuals and user guides at all-guides.com
XP SBC RU 125 16-06-2000 10:57
Instructions for use
A
D V I C E
Carefully read the complete procedure before starting!
You do not know the brand of your equipment/
you can not find the right code in the code list »
auto search:
1
Be sure your device is switched on.
2
Press the mode key for the device (TV or SAT) you want
MODE
to operate.
3
Press and hold keys mute and power simultaneously -for
about three seconds- until the green LED lights up.
(Release the keys: the green LED should stay on)
4
Press the power key repeatedly until the equipment
switches off. Make sure that you keep the remote control
pointed at your equipment.
– Each time the green LED flashes, another code is sent.
When the right code is found, the equipment switches off.
If you accidentally press the power key again, after the
equipment switched off, you miss the correct code!
If you accidentally skipped the code follow the next
procedure starting at step 5. If you did not skip the code go
to step 8.
5
Switch the equipment manually back on.
6
Press 'PROG–' (down only!) a couple of times.
PROG
-
7
Press the power key repeatedly until the equipment
switches off.
8
Press the mute key to lock the correct code in the SBC
RU125's memory.
– The green LED flashes twice.
C
H E C K
Switch equipment on manually. Press a few keys to check correct
response. If response is not correct, repeat procedure beginning
at step 1.
N
O T E
- The search time averages about 90 seconds.
(Maximum search time is 5 minutes for TV and 4 minutes for
SAT).
- If the LED blinks twice, after you pressed the power key (step 3),
this means you have tried all codes. If non of the codes worked,
try the Autosearch procedure again, starting at step 1.
4
Pagina 4