Setting The Stroke Rate; Attaching/Removing The Clip- Pings Collector; Working With The Device; Cutting Techniques - Parkside Performance PPHSA 40-Li A1 Traducción Del Manual De Instrucciones Original

GB IE
hands and away from your body.
Before switching the device on,
make sure that it is not touching any
objects.
Removing the blade guard:
1. Pull the blade guard (
safety cutter bar (2).
Switching on:
2.­ Make­sure­that­the­batteries­(15)­are­
inserted­(see­"Removing/inserting­the­
battery").
3. Press the security switch (17) on the
front­handgrip­(4).
4. Press the on/off switch (7). The device
runs­at­the­lowest­speed.­
For­setting­the­speed,­refer­to­the­sec-
tion­"Setting­the­stroke­rate".
Switching off:
5. Release the security switch (17) or on/
off switch (7).

Setting the stroke rate

After switching on, the device runs at the
lowest­speed.­You­can­read­off­the­current­
speed­from­the­light­on­the­scale­
on­the­operational­control­(6).
1. Press the button for setting the cutting
speed­(13)­to­set­the­stroke­rate.
Mode
Speed­(rpm)
Attaching/removing the clip-
pings collector
Attaching the clippings collector
1.­ First­slide­the­clippings­collector­(10)­
with the angled edge onto the safety
cutter bar (2).
30
9) off the
low mid
low mid high
1000 1500 1800
Removing the clippings collector
1.­ Pull­the­clippings­collector­(10)­for-
wards off the safety cutter bar (2).
Working with the device
While cutting, make sure that you
do not touch any objects, such as
wire­fences­or­plant­supports.­This­
can cause damage to the safety
cutter bar.
•­ If­the­blades­become­jammed­with­solid­
objects, switch the device off immedi-
ately and remove the batteries. Only
then should you remove the object.
•­ Avoid­over-stressing­the­device­while­
working.
•­ With­the­clippings­collector­in­place,­
remove­the­clippings­from­the­hedge­at­
horizontal cuts towards the user. This
makes­it­easier­to­collect­the­clippings.
Cutting Techniques
• Cut thick branches beforehand using a
branch­clippers.
•­ The­double-sided­cutter­bar­enables­cut-
high
ting in both directions or, with a swing-
ing action, from one side to the other.
•­ In­case­of­vertical­cutting,­move­the­
hedge­trimmer­uniformly­forward­or­up­
and down in an arc movement.
•­ In­case­of­horizontal­cutting,­move­the­
hedge­trimmer­in­a­sickle-shaped­move-
ment to the edge of the hedge, so that
cut branches fall to the ground.
•­ In­order­to­achieve­long­straight­lines,­
the­placing­of­tensioned­guiding­cords­
is recommended.