Bruder Mannesmann Werkzeuge 22310 Manual De Instrucciones página 14

Screw the bottle to the foam-nozzle and pull the trigger (19) of the spray-gun.

Spray detergent onto the dry surface and let it react, but not dry-out, for some minutes.

Remove the foam-nozzle (14) from the spray-gun, fasten the fan-nozzle (12), as

discribed above and clean the object with the jet-stream
Cleaning with your high-pressure cleaner
If necessary, first clean the object from coarse soil in high-pressure mode.

Spray the detergent onto the surface and allow it to soak in. Do not leave it to dry.

Spray off the loosened soil in high-pressure mode.

Fan Nozzle
By twisting the nozzle casing (22) the flow can be adjusted between jet (23) and spray (24)
via the fan nozzle.
Rotor Nozzle
The rotor nozzle (13) creates a rotating jet of water. This can be used to achieve rapid
cleaning of large areas of the ground or walls.
First follow the instructions above under the heading "Before Using Equipment".

Mount the rotor nozzle (13) onto the spray lance (11) as described earlier.

When the trigger (19) is pressed a rotating jet is produced.

Using the trigger gun in a sweeping motion algae and moss, for example, can be

removed from exterior surfaces.
Large-Surface Cleaner
The large-surface cleaner (17) facilitates the efficient cleaning of patios, paths and similar
large areas and, at the same time, offers the user optimal protection from splashes. The
high-pressure nozzles in the cleaning head are rotated by the water pressure. The casing
and the surrounding cleaning brushes create virtually no splashing.
Place the surface cleaner coupling (17) onto the spray lance (11) until you hear it click

into place. According to the requirements the extension (16) can be mounted between
gun and spray lance.
First place the large-surface cleaner on the surface to be cleaned and switch on the

high-pressure cleaner as described above. Without using excessive pressure, move
the large-surface cleaner across the surfaces to be cleaned.
WARNING: Never squeeze the trigger of the trigger gun unless the large surface

cleaner is positioned on the surface to be cleaned.
By use of the rotating nozzles and cleaning brushes, patios, paths and similar areas

can be thoroughly cleared of algae, moss and similar impurities without causing
splashes.
Finishing the Cleaning Process
Switch off high-pressure cleaner by turning the operating switch (5) to "OFF" and

disconnect the mains plug.
GB - 14