MESTIC MB-100 Instrucciones De Uso página 9

Gas connection
The device burns on propane / butane gas G30.G31 and is suitable for connection through a propane gas hose that
conforms to EN 559 or EN1763. Connect the rubber hose to the connecting piece of the device with a quarter-left
connection or a hose clamp. The gas hose may be a maximum of 150 cm long. Before installation, check whether the
operating pressure of the gas pressure regulator corresponds to the operating pressure of this appliance as stated on
the nameplate. Check all gas connections for leaks by means of a gas leak spray or soapy water. Never use an open
flame.
How to use
1. Turn all adjustment knobs to the lowest position (zero).
2. If the device has a lid, open it carefully
3. If the appliance is equipped with the wooden cutting board, carefully remove it.
4. Connect the controller correctly.
5. Perform a leak test before using the device.
6. Fully open the tap on the gas bottle.
7. The device is operated by turning the adjustment knob. Press the button and turn it carefully to the left until
you hear a click. If the gas burner does not ignite, turn the knob slower until it clicks. This gives the gas more
time to reach the gas burner.
8. When the gas flame is burning, it can be adjusted to the desired height.
9. If the gas stove does not work properly or if a gas smell is detected, immediately close the gas tap on the gas
bottle.
After use
Close the tap on the gas bottle after use. Then close the barbecue tap by turning it clockwise with this pointer to the
closed position.
ENGLISH