Rules Of Use; Preparations For Operation; Installing The Appliance - MSW Motor Technics MSW-M-PAT-1 Manual De Instrucciones

m) Do not use the pump and the accumulator tank to pump petrol or any liquid
with flash point below 37°C (98°F). Failure to follow the recommendations may
lead to explosion or cause serious injuries or death.
n) Do not exceed pressure in the tank. Pressure exceeding 125 psi (8.6 bar) may
lead to tank bursting and injuries.
o) Attach the hose accurately to inlet/outlet connectors using tie wraps. Failure
to follow this recommendation may cause flooding of and/or damage to the
equipment.
p) When the tank is mounted, first restore water supply, and then connect pump
power supply.
CAUTION! Although the appliance has been designed to be safe and has
been provided with adequate safeguards, and despite the use of additional
safety measures, there is still a low, residual risk of accident or injury during its
operation. Caution and common sense are advised when using the product.

3. Rules of use

The product is not suitable for use in water systems with a pressure valve, e.g. in
camping vans, yachts, boats.
The appliance
protects the pump
ensures enhanced warm water temperature monitoring.
The user is responsible for any damage caused by non-intended use.

3.1. Preparations for operation

INSTALLING THE APPLIANCE

1. Disconnect the pump's power supply.
2. Open the appliance's tap or drain valve.
3. Install the tank at any plane in the line at the pump discharge side.
4. Attach the hose to inlet/outlet connectors using tie wraps. Failure to follow
this recommendation may cause flooding of and/or damage to the equipment.
5. Restore water supply and then restore power supply. Allow water to flow
through the pump and leave the end discharge point to remove air from the
system.
6. The tank may be mounted in any position. To remove the tank from the
system, always disconnect the pump power supply and open the tap or the
appliance to safely release pressurised water.
CAUTION!
prevents from water hammers, reduces noise during operation,
(reduces the number of on/off
Reduce air pressure before disassembly!
cycles), and at the same time