Charging; Installation Instruction - KAISDA K6 Guia Del Usuario

4.3.If the battery is damaged because it has been dropped somewhere or
because of a biking accident, there might be a risk of electrolytes leakage.
Beware of chemical burns! And immediately stop using a damaged battery.
4.4Do not touch the battery without a cloth or gloves and make sure no acid
touches your eyes.

5. Charging

1. To charge the battery with the bike, simply place the bike within reach of the
power supply and plug it in. Note: The plug hole is located in the left of the
battery.
2. The battery can either be charged while on the bike or the battery can be
removed and charged at a place of your convenience.
3. The RED light indicates it is in charging and GREEN light indicates the battery is
fully charged. (Please put off plug from wall) Usually the charging time is 4-6
hours depends on the battery capacity remain.
4. Warning: Charging time over 10 hours is prohibited please kept it away from
high temperature environment and stores it in a cool place.

6. Installation Instruction

1. Open the carton, take our the e-bike, and cut the wrapping rope with tools.
2. Handlebar installation:
2.1 Insert the seat tube vertically and align it with the frame head tube.
The depth must exceed the minimum insertion depth marked on the seat
tube.
2.2 Align the standpipe so that the handlebar and the frame are at 90
degrees, and then use an M6 hexagon wrench to tighten the mounting screws
on the standpipe.
2.3 Adjust the correct position of the handlebar, and then use tools to lock
the handlebar cover.
2.1 2.2
-4-
2.3