Product Overview - wolfcraft TS 2500 Traducción Del Manual De Instrucciones Original

– Ensure that there is no one standing below the transport system when
going up or down steps, ramps or sloping ground. A possible loss of con-
trol over the transport system may result in collision and injuries.
– The transport system is not suitable for use under extreme temperatures
(air temperature below -10°C, solar radiation above +50°C). Use the
transport system only on a clean surface that is free of acid and grease.
– Never use the transport system to transport people or animals. Trans-
porting people may results in hazardous situations or a risk of injury from the
transport system tipping over.
– Never use the transport system as a trailer on bicycles or motorised
vehicles.
– Do not extend the nose plate and do not use it as a lever. Any technical
modifications to the product are prohibited.
– Examine the transport system regularly to make sure it is in perfect con-
dition. Stop using the transport system in case of a defect.
– Only use genuine wolfcraft spare parts.
– Before using the transport system, examine it to make sure it is in
proper condition and check the inflation pressure. The tyres should be
inflated to a pressure of 2 bar / 29 psi. If the pressure is lower, fill the
tyres with more air. Insufficient inflation pressure in the tyres may result in
loss of control.
– Inflate the wheels by hand. Specifically, do not use compressors. A com-
pressor set to more than 2 bar / 29 psi can cause the tyres to burst and thus
lead to injuries or property damage.
– If not using the transport system, make sure to protect it against humid-
ity and wetness during storage. Inappropriate storage conditions may res-
ult in damage through rusting.
– The transport system is not intended for commercial use.
INTENDED USE
The transport system can be used for the following purposes:
– As a hand truck, suitable for tall objects with a maximum weight of 150 kg.
– As a push cart, suitable for long and heavy loads with a maximum weight of
200 kg.
– For going up and down steps and ramps with a maximum rise of 20 cm and a
minimum run of 23 cm, with a load not exceeding the permissible payload of
100 kg.
The manufacturer does not accept any liability for property damage or personal in-
jury resulting from failure to observe the operating instructions.

PRODUCT OVERVIEW

PRODUCT DESCRIPTION
The TS 2500 Transport System offers a flexible 2-in-1 function for fast conversion to
a hand truck and push cart. The hand truck function is designed for transporting
tall objects with a maximum weight of 150 kg. The curved cross bar and back
panel enable reliable transporting of round objects. The folding mechanism of the
handle allows fast conversion for use as a wheelbarrow. This function offers a low
loading height as well as a maximum payload of 200 kg and is ideal for transport-
ing long objects with the nose plate folded up. The large, air-filled wheels as well
as the flexible tilt angle of the handle make it easy and comfortable to go up and
down steps. The transport system can be folded for space-saving storage.
SCOPE OF DELIVERY
Take the product out of the cardboard box and check that the contents are com-
plete and all illustrated parts are included, see Fig. 1.
TECHNICAL DATA
Product dimensions
(width x depth x height):
Product dimensions when folded up
(width x depth x height):
Load-bearing capacity of hand truck:
Load-bearing capacity of wheelbarrow: 200 kg
Load-bearing capacity on stairs:
Weight:
ASSEMBLY
ASSEMBLY TOOL
The following assembly tools are required:
Allen key:
2x
A/F 3
FITTING THE HANDLE
Unfold the transport system and fit the handles as shown in Fig. 2.
13
630 x 550 x 1260 mm
520 x 420 x 800 mm
150 kg
100 kg
16 kg