Emerson in sink erator F-201R Manual De Instrucciones página 4

Turn off water supply before starting.
Installation must comply with all state and local laws and regulations.
1
INSTALLING FILTRATION SYSTEM
A
Personal Injury: Do not locate filter above an outlet or other
electrical device. Install head and bracket so that connections
require no stretching, kinking or pinching of tubing.
B
from water
supply line
Property Damage: Tube runs need to form to the cabinet's
contours to allow storage space with no sharp bends. Tubes
need clean, perpendicular, burr-free cuts to ensure a true fit.
C
Two water
dispenser lines
From filter or
water supply line
Property Damage: Do not extend the
lines farther than the 16" provided.
D
Discharge tube
From water
supply line
It is normal for approximately 2 oz. of water to
discharge when filter is removed.
4
Mark hole locations for filter head
and bracket in a spot that allows
for filter replacement.
Drill 1/8" starter holes and attach bracket
to wall with wood screws, turning until snug.
Remove red filter cap, insert filter
cartridge into filter head and twist
clockwise until "LOCK" arrow on the
filter aligns with arrow on bracket.
then cut to length making sure the cut
is perpendicular and burr-free.
to dispenser
of filter head until it stops.
Press in again to ensure a secure fit.
outlet side of filter head until it stops.
Press in again to ensure a secure fit.
One water
dispenser line
From filter or
water supply line
Note: 3/8" fitting is required to make
To dispenser
connection to water supply.
Determine length of tubing required,
Insert a white 3/8" tube into inlet side
Insert the other white 3/8" tube into
Insert the copper tube(s) from the
dispenser into quick-connector using
"Y" connector for hot and cool models or
straight connector for hot-only models.
Connect the white 3/8" tube from the
right outlet on the filter head into the
quick-connect fitting until it stops.
Press in again to ensure a secure fit.
To remove tube(s) or plug from quick-connector,
depress the release ring and gently pull away.
To redirect filter replacement water
discharge, place 6" clear tube over
vent hole on the left side of filter head.
Connect remaining white 3/8" tube
to incoming water supply line.
(See Step 2.)