Technical Data; Noise/Vibration Information - REICH 3486 Datos Técnicos

4 I English
1

TECHNICAL DATA

Type
Dimensions mm
Weight kg (without fasteners)
Single sequential or contact actuation
Recommended operating pressure
range
Maximun permissible operating
pressure
Air consumption per driving
operation
Magazine capacity.
(No. of fasteners)
Penetration depth setting
Lighting
Fasteners: Brad nails
Brad length mm
Wire thickness mm
Recommended lubricant
1 litre special oil. Code No.
250 cm3 grasa especial. Code No.
2

NOISE/VIBRATION INFORMATION

Noise characteristic values *
A-weighted single-event emission
sound pressure level at work
station L pA, 1s
A-weighted sound power level
L WA, 1s, d
Vibration characteristic values **
Weighted r.m.s.-acceleration (a)
The noise level when working can exceed 85
dB (A). Wear ear protection!
* Measured values determined according to
EN 12549:1999.
** Measured values determined according to
ISO 8662-11:1999.
3 SUPPLIED WITH
1 Mini Brad nailer
1 Tool use and safety instructions
1 Technical data sheet
1 Transport case
Karl M. Reich Verbindungstechnik
4
Only those fasteners specifi ed under technical data
3486
(see 1) may be used.
222/240
When fi lling the magazine, hold the tool so that the
1.2 kg
muzzle is not pointing towards own body or towards
any other person.
Do not load the tool with fasteners with the safety
5 - 8 bar/
yoke or trigger depressed.
0.5 - 0.8 MPa
Place the tool on its side. Press the locking lever (l) and
pull the magazine rail (m) back. Introduce the nails tip
8 bar/0.8 MPa
downwards and push the magazine rail forward until
0.71 l at 7
it locks into place.
bar / 0.7 MPa
5
100
yes
The penetration depth of the nail head is adjusted
yes
using air pressure. Should this not suffi ce, a more
exact setting of the penetration depth can be achieved
by turning the setting nut (p).
15 - 35
Right-hand turn (U) = less penetration depth.
1.0 x 1.25
Left-hand turn (D) = more penetration depth.
9 4420
6
68 3868
-SINGLE TRIGGER RELEASE/RELEASE ON CONTACT-
A setting wheel on the trigger (s) can be turned to set
the type of actuation either to single trigger release
or release on contact (see symbol).
3486
7
82 dB(A)
Balancer for 10 - 20 N (1.0 - 2.0 kp),
cable travel 1.6 m (5.2 ft).
95 dB(A)
2.62 m/s2
FILLING THE MAGAZINE
FIL PENETRATION DEPTH SETTING
SWITCHABLE ACTUATION
ACCESSORIES
3486
Code No.
40 3393
REICH ®