METRO PROFESSIONAL makro PROFESSIONAL GSC240N Manual De Instrucciones página 16

• If the condenser coil is not cleaned at least 3
times per year, the efficiency of the appliance will
decrease significantly.
• The appliance may only be used again or stored
after it is dried completely.
GB
Defrosting
• The appliance defrosts itself automatically every
4 hours.
Note: During the defrost process, the appliance
slightly raises the temperature inside the cooling
compartment, so that the developed ice can melt.
This process is not harmful to the products stored
in the appliance and normally just takes 5-10
minutes and max. 30 minutes.
• You can also start a manual defrost process by
keeping the defrost button
3 seconds.
Note: The next automatic defrost process starts
4 hours after the manual defrost process.
Storage
• Before storing or when the appliance is not in
use, remove all contents from the appliance,
disconnect it from the power supply and clean the
appliance and its accessories thoroughly.
• Store the appliance in a dry, protected
environment at room temperature and out of the
reach of children.
• Keep the appliance's door open to avoid smell or
mold.
• To protect the appliance from dust, cover it
with a cloth that allows air circulation inside the
appliance.
4. Troubleshooting
WARNING!
• In case of failures or malfunctions, always unplug
the appliance immediately.
• Only perform the steps described in this
instruction manual! All further inspection,
maintenance and repair work must be performed
by an authorized service center or a similarly
qualified specialist.
• Should you require spare parts, always obtain
them from an authorized seller. Do not use
spare parts that are not recommended by the
manufacturer!
pressed for approx.
- 15 -
Possible
Problem
cause
Power plug
not connected
to electrical
outlet.
Appliance
does not
operate.
Supply cord is
damaged.
Control panel
is not set
correctly.
Appliance is
located near
heat sources.
Stored items
prevent
Appliance proper closing
does not of door.
achieve
required
Cooling
temperature.
compartment
overloaded,
filled with
hot items or
filled in a way
that prevents
proper air
circulation.
Door opened
and closed
too often.
Back of
appliance is
placed too
near to the
wall/ceiling
or to other
objects.
Appliance is
very noisy.
Appliance not
in a stable
position.
Solution
Connect power
plug to a suitable
electrical outlet.
Plug it in tightly.
Have supply cord
replaced by the
manufacturer, its
service agent or
similarly qualified
persons.
Set temperature
with control panel
as described in this
manual.
Move appliance
well away from heat
sources.
Reorder contents
of cooling
compartment or
remove several
items to allow door
to close.
Remove several
items, remove hot
items or reorder
contents of cooling
compartment to
allow air circulation.
Keep door closed
for a while.
Keep a minimum
distance of 5cm
to walls or other
objects. Keep a
minimum distance
of 20cm to the
ceiling.
Bring appliance into
a stable position by
adjusting the front
left foot. Make sure
that all wheels/feet
are firmly on the
ground.