Install The Battery Pack; Remove The Battery Pack; Operation; Start The Machine - GreenWorks BUG301 Manual Del Operador

7.1.1 ATTACH THE BONNET
1. Slip the edge of the application bonnet onto the foam pad.
2. Attach the application bonnet to the foam pad fully.
3. Ensure the bonnet is at the center of the foam pad.
7.1.2

INSTALL THE BATTERY PACK

WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
1. Align the battery pack with the grooves in the battery
compartment.
English
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
7.1.3

REMOVE THE BATTERY PACK

1. Push and hold the battery release button (5).
2. Remove the battery pack from the machine.
8

OPERATION

Do not handle battery pack, switch, or machine with wet
hands. Do not expose to rain or allow liquid to enter the
motor compartment.
8.1

START THE MACHINE

1. Apply the wax to the application bonnet evenly.
2. Put the machine on or against the surface being polished.
5
3. Slide the ON / OFF switch (1) to the O position.
4. Remove the application bonnet then attach polishing
bonnet to start polishing after waxing.
7
WARNING
EN
1