Stop The Machine; Maintenance; Clean And Maintenance; Store The Machine - GreenWorks BUG301 Manual Del Operador

EN
Use two hands when operating the machine. Using one
hand could cause loss of control and result in serious
personal injury.
• Before waxing, clear and dry the surface being
polished.
• Do not apply too much wax to the bonnet at one time. If
the foam pad gets saturated, the endurance of the pad
may be reduced.
• Always start and stop the machine on or against the
surface being polished.
8.2

STOP THE MACHINE

1. Set the ON / OFF switch to the off position.
9

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
9.1

CLEAN AND MAINTENANCE

• The bonnets are reusable and can be machined in cold
water using a mild detergent.
• Use a moist cloth with a mild detergent to clean the
machine and bonnets.
• Clean all moisture with a soft dry cloth.
• Use a small brush to clean the air vents.
10

STORE THE MACHINE

Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged components. If
it is necessary, replace the damaged components, tighten
screws and bolts, or speak to a person of an approved
service center.
4. Store the machine in a cool and dry location.
WARNING
NOTE
CAUTION
CAUTION
WARNING
NOTE
English
11

TROUBLESHOOTING

Problem
The motor does
not start when you
pull the trigger.
The machine
smokes during op-
eration.
There is too much
noise and/or vibra-
tion during opera-
tion.
12

TECHNICAL DATA

Voltage
Maximum Speed
Diameter
Weight (without battery
pack)
Vibration
Battery model
Charger model
The recommended ambient temperature range:
Item
Appliance storage tempera-
ture range
Appliance operation temper-
ature range
8
Possible cause Solution
Make sure that
The battery pack is
you tighlty install
not installed tight-
the battery pack in
ly.
the machine.
The battery pack is Charge the battery
out of power. pack.
1. Immediately
stop the ma-
chine.
The machine has
2. Remove the
damage.
battery pack.
3. Contact the
service center.
1. Stop the ma-
chine.
2. Remove the
battery.
The parts are
3. Inspect for
loose.
damage.
4. Check and
tighten loose
parts.
Do not use the ma-
The parts have
chine and contact
damage.
the service center.
24V
2,800 (±10%) min
10''
4.2 lbs. (1.9 kg)
2
6.13 m/s , K = 1.5 m/s
LB24A020 and other BAG
series
CAG801 and other CAG ser-
ies
Temperature
32°F (0°C) - 113°F (45°C)
32°F (0°C) - 113°F (45°C)
-1
2