Troubleshooting - Beko B3RMLNE444HW Manual Del Usuario

carbonate. Wash and dry thoroughly. Pre-
vent contact of water with illumination
components and the control panel.
CAUTION:
Do not use vinegar, rubbing alcohol
or other alcohol based cleaning
agents on any interior surface.
Stainless Steel External Surfaces
Use a non-abrasive stainless steel cleaning
agent and apply it with a soft lint-free cloth.
To polish, gently wipe the surface with a mi-
cro-fibre cloth dampened with water and use
dry polishing chamois. Always follow the
veins of the stainless steel.

9 Troubleshooting

Check this list before contacting the service.
Doing so will save you time and money. This
list includes frequent complaints that are not
related to faulty workmanship or materials.
Certain features mentioned herein may not
apply to your product.
The refrigerator is not working.
• The power plug is not fully settled. >>>
Plug it in to settle completely into the
socket.
• The fuse connected to the socket power-
ing the product or the main fuse is blown.
>>> Check the fuse.
Condensation on the side wall of the
cooler compartment (MULTI ZONE,
COOL CONTROL and FLEXI ZONE).
• The door is opened too frequently. >>>
Take care not to open the product's door
too frequently.
• The environment is too humid. >>> Do not
install the product in humid environments.
• Foods containing liquids are kept in un-
sealed holders. >>> Keep the foods con-
taining liquids in sealed holders.
• The product's door is left open. >>> Do
not keep the product's door open for long
periods.
Preventing Odours
The product is manufactured free of any
odorous materials. However, keeping the
food in inappropriate sections and improper
cleaning of internal surfaces may lead to
odours.
• To avoid this, clean the inside with carbon-
ated water every 15 days.
• Keep the foods in sealed holders, as mi-
cro-organisms arising from foods kept in
unsealed containers will cause bad odour.
• Do not keep expired and spoilt foods in
the refrigerator.
Protecting Plastic Surfaces
Oil spilled on plastic surfaces may damage
the surface and must be cleaned immedi-
ately with warm water.
• The thermostat is set to a very cool tem-
perature. >>> Set the thermostat to an
appropriate temperature.
Compressor is not working.
• In case of sudden power failure or pulling
the power plug off and putting back on,
the gas pressure in the product's cooling
system is not balanced, which triggers the
compressor thermic safeguard. The
product will restart after approximately 6
minutes. If the product does not restart
after this period, contact the service.
• Defrosting is active. >>> This is normal for
a fully-automatic defrosting product. The
defrosting is carried out periodically.
• The product is not plugged in. >>> Make
sure the power cord is plugged in.
• The temperature setting is incorrect. >>>
Select the appropriate temperature set-
ting.
• The power is out. >>> The product will
continue to operate normally once the
power is restored.
The refrigerator's operating noise is in-
creasing while in use.
• The product's operating performance may
vary depending on the ambient temperat-
ure variations. This is normal and not a
malfunction.
EN / 19
EN
ES
PT
FR