Gb Electric Bottle Heater And Steriliser - BabyOno 216 Manual De Instrucciones

Electric bottle heater and steriliser
Before the first use, please read the operation manual carefully
and keep it for future reference. The Babyono electric bottle and
jar warmer may be used for quick warming of liquids and foods
as well as keeping the water hot.
ELEMENTS OF THE APPLIANCE:
1. Water chamber
2. Signal light
3. Knob for the desired temperature
4. Bottle pad
5. Bowl
6. Lid
7. Power supply cord
TEMPERATURE ADJUSTMENT PANEL:
Temperature selection knob for setting and maintaining the
desired temperature. The signal lamp is on during the heating
operation, it turns off when the heating is done.
KEY TO SYMBOLS:
The knob turned to setting 1÷2 is recommended if you heat
up food in the bottle.
Settings 2 and 3 are recommended for heating up of dense food
in the bowl or in jars.
Settings 3 and 4 are recommended for speedy heating up of
food and for cleaning of the device.
The warmer in setting 4 is used to scald and sterilise teats and
bottles.
EXPLANATION OF KNOB SETTINGS:
During heating up, the temperature of the food will depend
on various factors, such as the amount, type and density of
the food, type of the bottle and the initial temperature of the
2
food (i.e. whether the food was stored in the refrigerator or at
room temperature). Each user should adjust the knob settings
to meet their individual needs. Remember to always check
the food temperature before feeding, especially in the case
of speedy heating up at high temperatures. In order to obtain
an even food temperature in the bottle, you should shake the
bottle from time to time or mix the food in the bowl or jar. The
jars should be heated up to approx. 70 °C (settings 2 - 3 of the
knob), and cooled directly before feeding.
HOW TO ASSEMBLE THE DEVICE:
Put the warmer on a smooth surface and make sure there
are no redundant things in the direct vicinity. Make sure
that the available power supply voltage meets the electrical
requirements of the appliance, then put the plug in the socket
(the appliance should be unplugged if it is not going to be used
for a longer time).
INSTRUCTION FOR USE
Before use:
1. Make sure that both the
bottle and the food are high
temperature resistant.
2. Make sure the appliance is
properly plugged to a power
supply.
3. Before heating up the food
make sure that:
- the bottle with liquid is
properly assembled, it is suggested that the cap should not
be removed
- jarred food: turn off the lid, but do not take it off
- pour fresh water to the warmer chamber to the level
compliant with the guidelines below:
- bottle which protrudes from the warmer: fill with water
up to 1-2 cm below the upper edge of the chamber,
- a jar that does not protrude from the warmer: 1 cm below the
upper edge of the jar
HEATING UP FOODS
Place the bottle or jar in the chamber, having prepared them
for heating in accordance with the guidelines specified in the
"Before use" section.
1) Pour water into the chamber (see: "Before use")
2) Set the knob to the desired position.
3) The signal light will turn on, which means the warmer has
GB