Cleaning Of The Device; Important - BabyOno 216 Manual De Instrucciones

started operation.
4) When the signal light turns off, carefully take the bottle or
jar out of the warmer.
5) If the food has not been heated up to the right temperature,
mix it up and put it back into the warmer.
6) Having completed the heating, turn the appliance off by
setting the knob to "0" position.
Note: The users who operate the appliance on a continuous
basis should allow for ca. 30-minute breaks between
subsequent heating operations. Otherwise the PTC system will
temporarily switch the appliance off so as to cool it down. If
there is no water in the warmer chamber, the device will keep
switching off until the temperature drops and then will switch
on again.
Due to microbiological and hygienic considerations, baby foods
should not be reheated. If the heated baby food is not eaten up
by the baby, it should be discarded.
STERILISATION
1. Insert the bottle pad into the warmer.
2. Pour clean water into the warmer so that it does not cover
the bottle pad (approx. 1 cm).
3. Insert teats or other sterilisable products and close the
warmer with a lid. Bottles should be inserted upside down.
4. Turn the knob to setting 4 and when the water begins
to evaporate, continue the sterilisation process for about 5
minutes.
5 After sterilisation, turn off the warmer and let the products
cool down.
NOTE: Please make sure the bottle heater is out of reach of
children at all times.
NOTE: If there is no water in the appliance, it will turn off
automatically. It will restart when its temperature drops (after
ca. 5 minutes).

CLEANING OF THE DEVICE

Pour a small amount of water and then scrub the device with
a scrubbing sponge. Next, pour out the water and wipe it dry
with a soft cloth.
In order to descale the plate, follow the following steps:
1 Pour 50 ml of water into the warmer chamber.
2 Pour a small amount of household vinegar (or lemon juice)
into the warmer chamber.
3 Set the control knob in the range between 3 and 4 and heat
up the solution for about 5 minutes.
4 Disconnect the power supply.
5 Put the device aside for about 30 minutes so that the
accumulated residue can soften, and then rinse the chamber.
6 If after descaling you can smell a specific odour in the
appliance, rinse it several times.
NOTE: To prevent scale formation, the inner container should
be cleaned on a regular basis. The failure to regularly clean the
container may shorten the life of the device or cause a specific
odour and problems with maintaining the device in a hygienic
condition. After cleaning, the solution should be poured out
and the warmer chamber should be rinsed.

IMPORTANT:

- Prior to switching the warmer on make sure the water level
is appropriate.
- For safety reasons please do not let the water to evaporate
completely from the warmer.
- Do not use the appliance if its cord or plug is damaged or it
is damaged in any other way. Never try to mend a damaged
warmer. If any part of the warmer is damaged, please contact
BabyOno service.
- Do not place your hands over the warmer. The steam released
from the warmer may causescalds.
- Before each subsequent use, the warmer should first be
emptied at all times.
- Please note that the warmer contains hot water. Please take
special care whenempting the warmer chamber.
- Check the food temperature during heating it up.
-ALWAYS CHECK THE FOOD TEMPERATURE BEFORE FEEDING!
- Having finished the food heating, always switch the appliance
off and unplug it.
- Never immerse the warmer and/or its power supply cord in
water.
- The appliance is intended for use by adult and responsible
persons.
- The product is not a toy. Keep it out of reach of children.
Children should besupervised by adults to make sure they do
not play with the appliance.
- Failure to observe this instruction manual may lead to
damaging the appliance or injuries.
- In emergency, first and foremost unplug the power supply
cord.
- The appliance is not intended for use by persons (including
children) with reduced physical, sensory and mental
capabilities, or lacking knowledge or experience, unless they
are supervised or instructed concerning use of the appliance by
persons responsible for their safety.
Voltage 230V ~50Hz
The alumunium
260 ± 10°C
surface temperature
Heating element PTC heating plate
Temperature control 25°C - 100°C (±5°C)
Rated volume Bowl volume: 180 ml
3