Operating Multiple Receivers; Setting The Remote To Control Other Components - Pioneer CU-RF100-U Manual De Instrucciones

Controlling the rest of your system
Setting What it does
READ The preset codes set for the different
input functions can be checked. See
PRESET ID
Confirming preset codes on page 16.
CHANGE If you have multiple Pioneer receivers,
amplifiers, etc., this setting can be used
RC MODE
to prevent other units from operating
simultaneously when the remote control
unit is operated. See Operating multiple
receivers on page 13.
EXIT
Exits the setup menu.
SETUP
Note
• You can cancel or exit any of the steps by
press and hold MULTI OPERATION for a
couple of seconds. To go back a step, press
RETURN.
• After one minute of inactivity, the remote
automatically exits the operation.

Operating multiple receivers

The remote control included with this receiver
can be used to operate up to three other
receivers (of the same model as this receiver)
in addition to this receiver.
operated is switched by inputting the preset
code to set the remote control setting.
• Set the remote modes on the receivers
before using this function (see receiver's
operating instructions).
1 Check that the remote control's MULTI-
ZONE selector switch is set to MAIN and that
the operation selector switch is set to
RECEIVER.
2 While pressing MULTI OPERATION, press
HOME MENU.
The remote display shows SETUP MENU.
Note
1 This function is only valid when RECEIVER is set to IR MODE at the remote control's IR/RF SELECT setting (page 7).
1
The receiver to be
Use / to select 'CHANGE RC MODE',
3
then press ENTER.
Use / to select the remote mode.
4
RC MODE 1 to 4 can be selected.
5 Press ENTER to set the remote mode.
The selected mode flashes for 3 seconds.
To operate another receiver, start over from
step 1 to input its preset code.
Setting the remote to control
other components
Most components can be assigned to one of
the input function buttons (such as DVD or
CD) using the component's manufacturer
preset code stored in the remote.
However, there are cases where only certain
functions may be controllable after assigning
the proper preset code, or the codes for the
manufacturer in the remote control will not
work for the model that you are using.
If you can't find a preset code that matches the
component you want to control, you can still
teach the remote individual commands from
another remote control (see Programming
signals from other remote controls on page 14).
• Devices may be assigned to the following
input function buttons.
MAIN
RECEIVER
ZONE2
BD DVD
TV CD
USB
iPod TUNER
MULTI CH
PHONO IN
INPUT SELECT
AUX
SOURCE
3
MULTI MULTI
OPERATION OPERATION
BDR
DVR HDMI
NET RADIO
HMG ADAPTER
OPTION
1 2
VIDEO CD-R
03
13
En