Using Multi Operations; Using System Off; Controlling Components - Pioneer CU-RF100-U Manual De Instrucciones

Controlling the rest of your system
8 Repeat steps 5 to 7 to program a
sequence of commands.
When you're finished, use / to select
9
'EDIT EXIT' from the menu and press ENTER.
You will return to the remote control Setup
menu. Select EXIT SETUP to exit.

Using multi operations

You can start multi operations with the receiver
switched on, or in standby.
MAIN
RECEIVER
ZONE2
BD DVD
1 Press MULTI OPERATION.
MULTI OPERATE flashes in the display.
2 Press an input function button that has
been set up with a multi operation.
The receiver switches on (if it was in standby)
and the programmed multi operation is
performed automatically.

Using System off

MAIN
RECEIVER
ZONE2
BD DVD
1 Press MULTI OPERATION.
MULTI OPERATE flashes in the display.
Note
1 With this remote control, the IR and RF modes can be selected separately for the individual input functions. To
perform a multi operation on a device (input function) for which the IR mode is selected, point the remote control
toward the remote sensor on that device.
2 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes
are sent.
3 • With this remote control, the IR and RF modes can be selected separately for the individual input functions. To turn off
the power of a device (input function) for which the IR mode is selected using the System Off function, point the remote
control toward the remote sensor on that device.
• When the power code of another brand is registered, the power on/off operation may be inverted. When using the
System Off function for a multi operation including the power codes of other brands, always check that the power of
all the components has turned off.
SOURCE
3
MULTI MULTI
OPERATION OPERATION
BDR
DVR HDMI
1
SOURCE
3
MULTI MULTI
OPERATION OPERATION
BDR
DVR HDMI
Press  SOURCE.
2
The command sequence you programmed
will run, then all Pioneer components will
2
switch off , followed by this receiver.

Controlling components

This remote control can control components
after entering the proper codes (see Selecting
preset codes directly on page 14). Set the
remote control operation selector switch to
SOURCE, then press the input function
buttons to select the component.
• TV CONTROL on the remote control are
dedicated to control the TV assigned to the
TV operation selector switch. If you have
two TVs, assign the main TV to the TV
operation selector switch.
MAIN
RECEIVER SOURCE
ZONE2 3
MULTI
OPERATION
BDR
BD DVD DVR HDMI
NET RADIO
TV CD HMG ADAPTER
USB OPTION
iPod TUNER 1 2
MULTI CH
PHONO IN VIDEO CD-R
INPUT SELECT LIGHT
AUX
SOURCE
TV RECEIVER
CH VOL
VOL
TV CONTROL
INPUT MUTE MUTE
AUDIO VIDEO
PARAMETER PARAMETER
3
TV CONTROL
INPUT MUTE MUTE
AUDIO VIDEO
PARAMETER PARAMETER
TUNE
TOOLS
LIST
TOP MENU T.EDIT
BAND GUIDE GUIDE
PRESET ENTER PRESET
CATEGORY RETURN
HOME
MENU
TUNE
iPod CTRL PTY SEARCH
STATUS PHASE CTRL CH LEVEL
THX MPX PQLS MEMORY
AUTO/ALC/
DIRECT STEREO STANDARD ADV SURR
PGM MENU
SIGNAL SEL SLEEP DIMMER AUDIO
A.ATT SBch MCACC INFO
DISP
HDMI OUT
CH
D.ACCESS CLASS
ENTER
CLR
03
19
En