Operation - Silvercrest SAST 18 A1 Instrucciones De Uso

Operation

ATTENTION! PROPERTY DAMAGE!
► The suction opening must always be open and may not be blocked.
Blockages lead to overheating and damage to the motor.
► Use the wet-suction nozzle
NOTES
► Make certain that the HEPA filter
► When vacuuming liquid, do not exceed the MAX marking in the dirt
container
► If the motorised brush attachment
longer turn, the charge indicator lamp
of the blockage, the working light
vacuuming. If this happens, remove the blockage as described in the section
"Cleaning the brush attachment". Slide the On/Off switch
position. To restart the appliance, slide the On/Off switch
or II.
1) Remove the appliance from the wall bracket
wall bracket
2) If required, place the appropriate nozzle in the suction opening. See section
"Using accessories".
3) To switch the appliance on, slide the On/Off switch
position I (= low power/wet suction
The charge indicator lamp
The working light
4) To switch the appliance off, place the On/Off switch
position. All lamps go out.
NOTE
After you have vacuumed up liquids, clean the dirt container i
►
immediately. Otherwise, bacteria or mould will build up inside! Ensure that
the HEPA filter
│ GB │ IE
■ 12
5
only at level I (low/wet suction
i
.
7
, remove the barrel plug
w
lights up yellow at level I, green at level II.
t
lights up.
z
is completely dry before using the appliance again.
z
is inserted before using the appliance.
6
is blocked so that the brush can no
w
flashes red after approx. 15 seconds
t
goes out and the appliance stops
7
or, if you are not using the
9
from the socket.
q
) or position II (= high power).
q
).
q
to the "OFF"
q
to position I
forwards into
back to the "OFF"
SAST 18 A1