Zeiss Colibri 5 Manual Breve página 10

ZEISS
10 SWITCHING ON SAFELY
Colibri 5/7 does not have a separate on / off switch.
After mounting it to a microscope it only has to be connected to a power outlet.
• Connect the Colibri 5/7 desktop power supply unit (Fig. 3/7) with a power supply cable to a power
outlet.
After a short initialization time Colibri 5/7 is ready for operation.
• Switch on the microscope.
Start the control software used (from ZEN 2.3 (blue edition) or third-party software).
•
If the control panel or the LED Trigger Box are connected, they will be powered via Colibri 5/7 and are
also ready for use.
Depending in the existing microscope equipment, ensure the correct connection type as follows:
• Connect the connection cable of the desktop power supply unit (Fig. 3/7) to the Power connection
socket (Fig. 3/5) of the lamp module (Fig. 3/1).
• If used, connect the control panel (Fig. 3/8) with connecting cable to the Remote connection socket
(Fig. 3/2) of the lamp module.
• If used, connect the LED Trigger Box (Fig. 3/9) with connecting cable to the Breakout connection
socket (Fig. 3/3) of the lamp module.
• If the microscope has a TFT display, connect the CAN connection socket (Fig. 3/4) of the lamp module
via the CAN cable to the microscope stand.
• If Colibri 5/7 is to be controlled via a third-party software on the PC, connect the USB connection
socket (Fig. 3/6) of the lamp module via USB cable to the PC.
8
SWITCHING ON SAFELY
423052-6044-008
Colibri 5/7
09/2017