Before Use; Inserting / Replacing Batteries (Transmitter); Inserting / Replacing Batteries (Receiver); Connecting The Temperature Sensor - FLORABEST HG02064 Instrucciones De Utilización Y De Seguridad

When inserting ensure the correct
polarity! This is shown inside the
battery compartment!
Clean the contacts on the battery
and in the battery compartment
before inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.

Before use

R emove all packaging material.
Inserting / replacing batteries
(Transmitter)
E nsure that the product is switched off before
inserting / replacing the batteries.
R emove the hook-and-loop fastener
battery compartment cover
O pen the battery compartment cover
ing the slide fastener in the direction of the arrow.
Insert two 1.5 V
compartment
This is indicated on the inside of the battery com-
partment
R eattach the battery compartment cover
battery compartment
click audibly.
Inserting / replacing batteries
(Receiver)
E nsure that the product is switched off before
inserting / replacing the batteries.
P lace the receiver
fastening clip
S lide the battery compartment cover
pressing down on it gently.
Insert two 1.5 V
compartment
This is indicated on the inside of the battery com-
partment
P lace the battery compartment cover
the battery compartment
ing clip
9
snaps into place.
Connecting the temperature
sensor
Insert the connector
into the socket
14
ter . The temperature sensor
13
in the holder above the transmitter
AAA batteries into the battery
. Ensure correct polarity (+ and -).
18
.
18
18
on its front and remove the
1
by sliding it to the left.
9
AAA batteries into the battery
. Ensure correct polarity (+ and -).
10
.
10
by sliding it into the bracket until it
15
on the side of the transmit-
16
21
.
20
. Please note that it will
and insert the fasten-
10
of the temperature sensor
may be kept
14
13
behind the
by push-
20
to the
20
off while
8
back onto
8
.
GB/IE 27