BIEMMEDUE TH 15 Manual De Instrucciones página 11

Before using the equipment, carefully read all of the instructions and follow them
scrupulously. The manufacturer cannot be held responsible for damage to persons and/or
property caused by improper use of the equipment.
This instruction manual is an integral part of the equipment and must therefore be stored
carefully and passed on with the unit in the event of a change of ownership.
CONNECTING THE UNIT TO THE ELECTRICAL CURRENT
ATTENTION:
· Make sure the electrical specifications on the technical data label of the unit correspond to
those of the electrical network.
TT, TTX, TC, TCX models only: Make sure the direction of rotation of the turbine is correct.
·
This can be verified by checking if there is a vacuum or air depression at the vacuum inlet. If
not, the direction of rotation can be corrected by reversing the polarity of the unit's plug.
TURNING ON THE UNIT
The switch must be in the "0" or "off" position.
·
· Attach the plug to the electrical current socket.
Turn on the unit by pressing the switch in the "I" or "on" position.
·
· Make sure the direction of rotation of the turbine is correct by verifying air depression at the
vacuum inlet as described above.
TO EMPTY THE RECOVERY TANK
Turn off the unit (switch in the "0" position.
·
· Disconnect the plug from the electrical current socket.
· Release the tank by raising the tank fixture handle bar.
· Remove the tank, and proceed with the emptying and cleaning procedures.
· Put the tank back into its original position and fix it in place by pressing down on the fixture
handle bar.
· Never leave waste material of any kind in the tank for long periods of time.
· Do not fill the tank over the limit of the warning peep hole.
TO CLEAN THE FILTER
· Make sure the unit is turned off (switch in the "0" position).
The filter can be cleaned using the special filter-cleaning handle on the lid or on the side of the
·
upper tank.
TO REPLACE THE FILTER
· Make sure the unit is turned off (switch in the "0" position).
· Disconnect the plug from the electrical current socket.
· Unlatch the lid, raise it and remove the filter.
· Using a screw driver, loosen the fixture bank around the filter and remove the filter from the
ring.
· Replace the filter with a new one, tighten the same original fixture band around the ring, and
replace the filter assembly back into its original position on the tank.
· Make sure the filter cleaning handle on the lid is perpendicular to the suction hose.
· Close the latches on the lid.
EN
IMPORTANT