Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Notes
During Assembly
Use
a
soft platform below the parts to avoid scratches and damages.
Please
note you install the panels
with
the
UV
protected
side
out (marked with
"THIS
SIDE
OUT")
and remove the sticker
as
panels
are in place.
Product dimensions
can be
adjusted to your specific
needs:
1. The
wall-mounting profile (top-back)
can be
adjusted from 260
to
305 cm
(102.4" to 120.1")
above ground.
The
adjusting
is
done when measuring and drilling (Step
7).
Please
note the installation recommendations' height suggested
in
Diagram
A.
It
is
possible to fix the Patio Cover back wall
height
at
the lowest point of 260 cm/102.4".
This
method
is
optional if the assembly
conditions
and
exterior
walls do
not allow to follow the suggested installation
as
appears
in
the manual.
Please
note
that
the product appearance may slightly change
as
a
result,
however snow load weight does not change.
2.
Poles
distance from the wall
can be
adjusted from 226
to 286
cm
(89" to 112.6")
as
suggested
in
Diagram
Bl.
Poles
distance from the
side edges can
be
adjusted from
0
to
54 cm
(0" to 21.3")
as
suggested
in
Diagram
B2.
The
adjusting
is
done after assembly and before anchoring (Step 19)
by
sliding
poles and
profile
1041 at
the roof profiles' channels.
3. Wall
mounting
and distance from the wall determine the roof angle and the total depth
of
the product (distance
of gutter
from
the wall). Higher wall mounting and shorter distance between wall and
poles increase
the roof angle and shorten the total depth
a
s
suggested
in
Diagram
C.
THIS SIDE
OUT
Steps
Step 6: Apply silicone
sealants on
the inner part of 8116 & 8117 and connect to the profile.
Step 10: Apply silicone sealants above beam 7288,
in
order to prevent water from seeping
in.
Step
12: Make sure
that the angle between the
back wall
profile and the panel supporting profiles
is
90
degrees. Assembly
of
the panels should start from the middle of the patio cover to
each side
alternately.
Step
14: Please
note you install the panels
with the
UV
protected
side
out (marked with
"THIS SIDE OUT")
remove plastic sticker
as
panels
are
locked
in place.
Step
19:
Adjust the
poles (inside
out
and sideways) by sliding them to their final position prior to anchoring.
Make
sure
that the
poles distance
from the
Patio
cover
side
edge does not exceed 54 cm/21.3".
Step
20:
Anchoring this product to the ground
is
essential to its
stability
and rigidity.
It
is
required to complete this stage
in
order for your warranty to
be
valid.
*Tighten
all screws
when completing assembly.
Note:
The
wall anchoring kit supplied
with
this product
is
suitable for concrete or solid brick walls
only.
Other wall types need
an
accordant wall fixation kit.
II
260-305cm
102.4"-120.1"
226-286cm
89"-
112.6"
'
.
17°
.
13°
+
+
Publicidad
Tabla de contenido
