Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Please read
these
instructions carefully before you start to
assemble this product.
Please
carry
out the
steps
in
the order
set
out
in
these instructions.
Keep these
instructions
in
a
safe
place
for future
reference.
Fil
When
encountering the information
icon, please refer to the relevant
assembly step for additional comments and
assistance.
11
H
This icon
indicates
that
the installer should
be
inside the product.
Safety
Some parts may have sharp edges. Please be careful when
handling
components.
IRAlways
wear gloves,
eye
protection,
and long
sleeves
when assembling
or
performing
any maintenance on
your product.
RTo
prevent injuries, do not allow children to
play
under the product
during
assembly.
Before Assembly
RThis
product
is
suitable for
Palram's Patio Covers
range
RIt
is
highly recommended to
be assisted by
a
second person
in
some steps.
RSort
the parts and check according to the contents parts
list.
RPrior
to the installation,
some parts
of
the
Patio cover need
to
be
dismanteld, it
is
recommend to
keep
them
in
a
safe
place
for future
use.
IPeriodically
check the kit's components to
assure
that
it remains stable.
RNote:
Use
only the parts registered
in
the content
list,
which
are
compatible
with your
Patio Cover's
gutter
(7999 & 8119), some parts may be surplus.
During Assembly
In
case
that
you already own Palram Patio cover it
is
necessary
to
dismantle
parts
as
described
in
Step
1
in
the kit assembly manual.
Option
No.
1
Step
1
b
Sierra:
In
order to perform this
stage,
the
gutter
head
must
be
removed.
Step 4: Select
option
no.
1
if
you
would
like
to
mount
the supporting
poles
in
different position than the merged position (using part
#7431).
Please
continue
from this position until step
6.
(skip step 7&8)
continue to
step no.
9.
Step 6:
Please
make sure
that
distance from the poles and the kit connection to
original patio cover does not
exceed 60 cm.
Option
No.
2
Step 4: Select option
no.
2
if the setting position of the mounting
poles
is
not
relevant.
Please
follow
from step
7.
Step
7: It
is
optional to
use
the existing pole to support the connection
between the new extension and the original patio
cover.
In
such
a
case please
store the extra pole
for future
use
or dispose properly.
Step 11: Tightening of the bolts
is
done from
inside.
Pay
attention:
while installing the
kit,
alignment with original
patio cover
is
important.
Tighten
all screws
when completing
assembly.
Publicidad
Tabla de contenido
