NOTE
►
Press the MODE button
stage modes. The MODE indicator lamp button
5) To switch the hob
tor lamp
NOTE
►
If no button is pressed within a 2-hour period, the appliance will switch
itself off even if the hob
more than two hours, or to keep food warm for more than two hours, adjust
the desired time using the timer (see the "Timer" section). In this way, times
of up to three hours can be set.
►
After switching off in standby mode, the appliance's fans continue to run
for a while to discharge the heat. As long as the hob
of more than 60°C, "- H -" will be shown on the display
6) Pull the mains plug out of the mains socket if you no longer wish to use the
appliance.
CAUTION – PROPERTY DAMAGE!
►
Only pull the mains plug out of the mains socket once the fans have
stopped working, as the appliance might be damaged otherwise.
Safety cut-off
■
For safety reasons, the pan detection automatically switches the appliance
off (into standby mode) if you remove the cooking pot from the hob
to place a cooking pot on it.
■
If you remove the cooking pot from the hob
approx. one minute. The appliance will then switch off. If you place the cook-
ing pot back on the hob
will be retained.
SIKP 2000 E2
–
In the temperature stage mode, the preset temperature of 120°C
appears on the display
–
In the power stage mode, the preset power level of 1000 watts
appears on the display
off, press the On/Off button
goes out.
is still working. If you wish to cook a dish for
to switch between the temperature or power
. The "°C" indicator lamp
. The "P" indicator lamp
, a signal tone will sound for
within 1 minute, the previously defined settings
lights up.
lights up.
lights up.
. The On/Off indica-
has a temperature
.
or fail
29
GB│IE
│
■