W)Lan Connection - Resol KM2 Manual

Carry out the connection of the device  to the controller / other mod-
ules in the order described below:
1. Connect the data cable (VBus , ) to the controller . If necessary, extend the
®
cable using a 2-wire cable (bell wire).


VBus1 VBus2
Connection terminals of the communication module
Note
The VBus2 terminals have no function!
2. Connect the device to the mains by means of the mains adapter .
3. For a direct connection to a router, connect the device to a router  using
the network cable (included with the device, ). Alternatively use the WLAN
connection.

www


3.3

(W)LAN connection

The device can be connected to a router by using a network cable (CAT5e, RJ45
or similar) or via WLAN (see chap. 4.2 on page 26).
Î Connect the network cable included to the LAN connector of the router and
to the LAN connector of the device.
For the next step of commissioning, see chap. 5.4 on page 28.
The LAN connector is located on the front side of the device and supports trans-
fer rates of up to 100 MBit per second.


25