Finding The Communication Module In The Network; Devicediscoverytool; Web Interface; Menu - Resol KM2 Manual

6

Finding the communication module in the network

6.1

DeviceDiscoveryTool

The DeviceDiscoveryTool is a software that displays RESOL products connected
via the local network.
There are different possibilities to start the DeviceDiscoveryTool:
• Starting the tool from the hard disk after having downloaded it from https://
www.resol.de/de/software
• Starting the tool from VBus.net (under Tools)
Starting the DeviceDiscoveryTool
In order to start the DeviceDiscoveryTool, proceed as follows:
1. Open the folder discovery-tool-xxx.
2. Start discovery-tool Setup xxx.
3. Confirm all following dialogues with OK.
4. Click Start/Programs/discovery-tool.
5. Click Find devices.
All LAN-enabled RESOL products available in the network will be displayed.
6. Click the Open Web interface button of the corresponding device.
A new window with the Web interface will open.
7. Enter the password, see chap. 7.1 on page 29.
Note
The password can be found on the underside of the housing (Web-In-
terface).
7

Web interface

The Web interface is integrated in the device and runs on an Internet browser.
The Web interface has the following functions:
• Display device status
• Configure device
7.1

Menu

All main menus and the Login menu item are displayed in the bar at the top of
the Web interface.
Note
The menu structure may change in later firmware versions.
Note
The indicated information and setting possibilities depend on the user
mode selected, see chap. 7.2 on page 30.
In order to use the Web interface to its full extent, a login is required. In order to
log in, proceed as follows:
1. Click Login on the menu bar.
The Login window appears. The password can be found on the underside of the
housing (Web-Interface) or on the last page of this manual.
Web-Interface:
WLAN-AP -
SSH
2. Enter the password into the Password field.
3. Click the Login button.
XxXxXxXxX
xxxxxxxx
root xXxXXXX
29