universalblue UVTO1700-20 Manual De Instrucciones página 15

oscillation of the device.
14. Position
to enjoy maximum speed without
oscillation of the device.
15. Position : to switch off the fan
16. Position : to select minimum speed
together with the oscillation function
17. Position : to select medium speed
together with the oscillation function
18. Position : to select the maximum
speed together with the oscillation
function
19. Position : to switch off the fan
Digital tower fan (control panel,
picture 04 on page 5)
The digital model can be used through the
LED display located on the fan's body or by
using the remote control.
Please familiarize
following functions before using the
device:
20. Speed button
button to set the fan speed to high,
medium or low.
21. On/off button
button to switch the device on or off.
In addition, by pressing the button
again, the fan can be put into standby
mode.
22. Timer button
button as many times as necessary to
set the timer up to 15 hours.
23. Oscilation button
"osc" button to swing the fan. Pressing
this function again will stop the fan.
24. Wind button
button repeatedly, and the wind will
circulate in the order of "normal
wind - natural wind – sleep mode"
according to the desired mode in each
case.
: select this function
see
yourself with
: press the "speed"
: press the "on/off"
: press the "timer"
: press the
: press the "wind"
Display
(See picture 05 on page 5)
25. Timer: 1 hour.
26. ON
27. Timer: 2 hours.
28. Timer: 8 hours.
29. Night mode
30. Natural wind mode
31. Swing
32. Timer: 4 hours.
When using digital tower fan's control
panel or remote control the display will
turn on, You will be able to see which
function is on due to a light will appear in
each established function.
The number that appears in the middle
shows selected speed.
Note: The display will automatically turn
off after 60 seconds from the last time it
was used, to help save energy. Touching
the
the screen again will turn the display on.
Remote control
(See picture 06 on page 5)
33. Off
34. On
35. Speed
36. Swing
37. Timer
38. Mode
In case your fan includes a remote control,
2 batteries of the number 7 must be
incorporated in order to be able to use it.
To do this, remove the back cover, place the
batteries in the correct position and close
it again.
When using the remote control, the remote
control emitter (located on the front of the
remote control) must be aligned with the
signal reception window on the product
body (located on the front of the body).
Avoid direct sunlight to the reception
window, so as not to affect the reception
effect.
EN
15