Useful Information; Control Panel - Electro Depot VALBERG 14S42 D DX AD 929C Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

B
Using the appliance
1. Press the Start/Pause button to stop the wash.
2. Press the "Programs" button for 3 seconds to cancel the program.
3. Press the "Programs" button to select the program of your choice.
4. Press the "Start/Pause" button; the dishwasher will start after 10 seconds.
3 seconds
Adding forgotten tableware
• You can add forgotten tableware at any time before the detergent dispenser has opened.
In this event, follow the below instructions:
1. Press the Start/Pause button to stop the wash.
2. Wait 5 seconds before opening the door.
3. Add the forgotten tableware.
4. Close the door.
5. Press the "Start/Pause" button; the dishwasher will start after 10 seconds.
After 5 seconds
WARNING : It is dangerous to open the door during the
cycle as the hot steam could burn you.
32
EN
C

Useful information

Cleaning and care
Exterior maintenance of the appliance
Door and door seal
• Regularly clean the door seals with a soft damp cloth to
remove food residues.
• When loading the dishwasher, food and drink residue can
spill down the sides of the dishwasher door.
• These surfaces are outside of the tub and the water from
the spray arms does not reach them.
• Any residue should be wiped off before closing the door.

Control panel

• If necessary, the control panel should only be wiped with a
soft damp cloth.
WARNING :
• To prevent water from entering the door lock and electrical
components, never use any type of cleaning spray.
• Never use abrasive pads or cleaners on the external
surfaces of the appliance, as they may scratch the finish.
Some paper towels can also scratch or leave marks on the
surface.
33
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

972279

Tabla de contenido