Electro Depot VALBERG 14S42 D DX AD 929C Instrucciones De Uso página 23

C
Useful information
Problems Possible causes
White film on the inner Mineral content in hard
surface water.
The objects affected are not
resistant to rust.
You did not immediately
start a program after adding
Rust spots on cutlery
regenerating salt. Salt
entered the wash cycle.
The cover of the water
softener is loose.
Knocking sounds from the A spray arm is hitting an
dishwasher object in one of the racks.
Rattling sounds from the Tableware moving in the
dishwasher dishwasher.
This may be related to the
Knocking sounds from
installation or the diameter
water pipes
of the pipes.
42
Solutions
• To clean the inside of
the appliance, use a damp
sponge with dishwasher
detergent and wear rubber
gloves.
• To avoid the risk of
foaming, never use
cleaning agents other than
dishwasher detergent.
• Avoid putting objects in
the dishwasher that are not
rust-resistant.
• Always run an empty
wash program after adding
salt.
• Do not select the Turbo
function (if available on
your model) after adding
regenerating salt.
• Check that the water
softener cover is closed
correctly.
• Stop the program and
reposition the objects that
being hit by the spray arm.
• Stop the program and
rearrange the tableware.
• This does not affect the
dishwasher's operation.
• If in doubt, consult a
qualified plumber.
EN
C
Useful information
Problems Possible causes
The tableware has not been
correctly positioned.
The selected program was
too gentle.
Insufficient detergent was
released.
The tableware is not clean.
Objects are blocking the
movement of the spray
arms.
The filter system is not
clean or has not been
correctly inserted in the
bottom of the tub. This can
block the spray arms.
A combination of soft water
The glasses are cloudy
and too much detergent.
In areas with hard water,
White spots appear on
limescale marks may
dishes and glasses
appear.
Black or grey marks on Aluminium utensils have
dishes rubbed against the dishes.
Detergent left in the Tableware is blocking the
dispenser detergent dispenser.
43
Solutions
• Refer to the chapter
"Preparing and loading
tableware".
• Select a more intensive
program.
• Use more detergent, or
use a different type.
• Reposition objects so that
the spray arms can freely
rotate.
• Clean and/or insert the
filter correctly.
• Clean the spray arm jets.
• Use less detergent if your
water is soft and select
a shorter cycle to wash
glasses.
• Add more detergent.
• Use a mildly abrasive
cleaner to remove these
marks.
• Load the tableware
correctly.
EN