Accessories And Attachments; Carton Contents; Installation - KNOVA KN WL-12M Manual Del Usuario

ELECTRICAL REQUIREMENTS
GUIDELINES FOR EXTENSION CORDS
USE PROPER EXTENSION CORD. Make sure your extension
cord is in good condition. When using an extension cord,
Be sure to use one heavy enough to carry the current your
product will draw. An undersized cord will cause a drop in
line voltage, resulting in loss of power and cause overheating.

ACCESSORIES AND ATTACHMENTS

RECOMMENDED ACCESSORIES
WARNING
To avoid injury:
• Use only accessories recommended for this machine.

CARTON CONTENTS

UNPACKING AND
CHECKING CONTENTS
Carefully unpack the machine
and all its parts, and compare
against the illustration following.
WARNING
• To avoid
injury from unexpected
starting, do not plug the power
cord into a power source
receptacle during unpacking
and assembly. This cord must
remain unplugged whenever
you are assembling or
adjusting the machine.
• If any part is missing or
damaged, do not plug the
machine in until the missing
or damaged part is replaced,
and assembly is complete.

INSTALLATION

1. Installing handle to handwheel.
Attach handle
screw through
handle hole
onto the
handwheel,
secure it by
a screwdriver.
1
5
8
9
6
7
Handle
Handle
screw
3
Be sure your extension cord is properly wired and in good
condition. Always replace a damaged extension cord or have
it repaired by a qualified person before using it. Protect your
extension cords from sharp objects, excessive heat and damp
or wet areas.
• Follow instructions that accompany accessories.
Use of improper accessories may cause hazards.
• Use only accessories designed for this machine
to avoid injury from thrown broken parts or work pieces.
• Do not use any accessory unless you have completely
read the instruction or operator's manual for that
accessory.
2
3
4
10
11
12
2. Installing
the tool holder
Take the pan
head screw from
base, install
the tool holder
to base by using
the pan head screw.
Pan head
Unpack carton; check you machine
to see parts listed below:
No. Description
1. Lathe
2. Tool rest
3. Handle
4. Handle screw
with rubber ring
5. Face plate
6. Live center
7. Spur center
8. Knockout rod
9. Wrench
10. Tool holder
11. 5 mm Hex wrench
12. 3 mm Hex wrench
screw
Qty
1
1
1
1
1
1
1
1
1
1
1
1