Tabla de contenido

Publicidad

13
13

NAIL

(46 used in this step)
Unfold the BACK (J) and lay it over your unit.
Make equal margins along all two long edges and the two short edges of the BACK (J). Push on opposite corners of your unit if
needed to make it "square".
Fasten the BACK (J) to your unit using the NAILS (1N).
NOTE: Be sure to tap NAILS into the holes that line up over the SHELF (I).
NOTE: Perforations have been provided for access through the BACK. Carefully cut out the holes needed.
414720
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line up
over the SHELF (I).
J
1N
www.sauder.com/services
Page 17

Publicidad

Tabla de contenido
loading

Tabla de contenido