Nail - Sauder 427470 Manual Del Usuario

Step 12
å
Carefully turn your unit over onto its front edges. Unfold the LARGE BACK (R) and lay it over the upper portion of your unit.
å
Make equal margins along all four edges of the LARGE BACK (R). Push on opposite corners of your unit if needed to make
it "square".
å
Fasten the LARGE BACK (R) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the LOWER TOP (J).
å
Unfold the SMALL BACK (S) and lay it over the lower portion of your unit.
å
NOTE: The SMALL BACK (S) will overlap the LARGE BACK (R) as shown in the enlarged diagram.
å
Make the bottom edge of the SMALL BACK (S) even with the BOTTOM (K). Then, make equal margins along the side
edges of the SMALL BACK (S).
å
Fasten the SMALL BACK (S) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the LOWER TOP (J).
å
NOTE: Perforations have been provided for access through the BACKS. Carefully cut out the holes needed.
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
The SMALL BACK
will overlap the
LARGE BACK.
www.sauder.com/service
These holes must line up
over the LOWER TOP (J).
R
427470
8
1N

NAIL

(60 used in this step)
The perforations
should be here.
S
K
Page 17