Descargar Imprimir esta página
Vermont Castings Signature VCS3008BI Serie Guía De Instalación Rápida
Vermont Castings Signature VCS3008BI Serie Guía De Instalación Rápida

Vermont Castings Signature VCS3008BI Serie Guía De Instalación Rápida

Ocultar thumbs Ver también para Signature VCS3008BI Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

CAUTION: Some parts may have sharp edges; to avoid injury, wearing gloves during assembly
is strongly recommended.
Step 1: Attach the Battery Holder
Parts Required:
(1) Battery Holder Bracket
(2) U-clip Fasteners
(2) #10-24 x 1/2" Bolts (stainless)
Tools Required: Philips or Robertson (square
head) screwdriver.
NOTE: Remove the grease tray from under the
grill body (located below the console) and set it
aside until you are finished with Step 2.
Slide the U-clips onto the battery holder and align
the holes. Make sure the flat side of the U-clip is
on the same side as the flat side of the battery
holder. (Fig. 1)
Place the battery holder onto the inside of the bottom left flange of the console
as shown in Figure 1a. Fasten it by using two (2) #10-24 x 1/2" bolts (stainless).
Step 2: Install the Batteries
Parts Required:
(1) Plastic Battery Case
(8) "AA" Batteries (not included)
Wire Harness (already installed)
Place the eight (8) "AA" batteries in the
battery case as shown on the case. Locate
the battery connector under the console.
It will be hanging freely in the same area
as where you installed the battery holder
in Step 1. Attach the connector to the battery case and then
place the case in the battery holder. (Fig. 2)
NOTE: For VCS5008BI models, shorten the connector wire
by wrapping it around the battery case (Fig. 3) before placing
the case in the battery holder.
Step 3: Operating Instructions
To turn the lights on and off, press the "Console Light" button
already installed by manufacturer.
NOTE: To ensure battery longevity and to prevent damage to
the lights, it is recommended the lights be turned off when the
BBQ is not being used. Please also refer to the battery manu-
facturer's notes and recommendations as they offer advice on
the safe handling, usage and disposal of their products.
Battery Installation Procedure
Installation des piles
Procedimiento de instalación de las baterís
For Built-In Grill Models:
Pour les modéles :
Para el modelos:
VCS3008BI Series, VCS5008BI Series
Battery
Holder
U-Clip
Figure 1
Figure 2
Battery Connector
Battery Case
Batteries
B253
����
������� ����
�����
Figure 1a
B252
����
������� ������
U-Clip
�����
����
������� ������
�����
����
������� ������� ����
B264
Figure 3
B265
B254
50004812 12/07 Rev. 1
����
��� ���� ����
�����

Publicidad

loading

Resumen de contenidos para Vermont Castings Signature VCS3008BI Serie

  • Página 1 Battery Installation Procedure Installation des piles Procedimiento de instalación de las baterís For Built-In Grill Models: Pour les modéles : Para el modelos: VCS3008BI Series, VCS5008BI Series CAUTION: Some parts may have sharp edges; to avoid injury, wearing gloves during assembly is strongly recommended.
  • Página 2 Installation des piles MISE EN GARDE : Certaines pièces peuvent avoir des bordures tranchantes; pour éviter les blessures, il est vivement recommandé de porter des gants pendant l’assemblage. Étape 1 : Installation du support pour les piles Figure 1a Pièces requises : (1) Support pour les piles (2) Attaches pour la pince en U (2) Boulons #10-24 x 1/2 po (acier inoxydable)
  • Página 3 Procedimiento de instalación de las baterías Precaución: Algunas partes tienen bordes filosos; para evitar lesiones, le recomendamos ampliamente usar guantes mientras ensambla el asador. Figura 1a Paso 1: Sujete el portador de la batería Pizas requeridas: (1) Soporte del portador de la batería (2) Afianzadores de clip en U Portador de (2) Pernos 10-24 x 1/2”...
  • Página 4 Replacement parts / Pièces de rechange / Partes de repuesto Ref. Description VCS3008BI VCS5008BI 1. Wire Harness / Faisceau de câblage / Arnés 50004727 50004324 2. Back Lit Bezel (4) Long Stem / Enjoliveur de l’éclairage par l’arrière long / Bisel de luz de fondo largo 50004328 50004328...

Este manual también es adecuado para:

Signature vcs5008bi serie