Storing The Machine; Disposing Of The Machine - BIEMMEDUE Magnum Plus Manual De Instrucciones

9 Storing the machine

9.1 Storing the machine
If the machine is not used for long periods, protect exposed parts
(not protected by paint, surface treatment or plastic) with protective
rust prevention oils. If the machine is not to be used for particularly
long periods, you should also clean it thoroughly. After performing
these operations, seal the machine inside an opaque black
multilayer nylon bag together with a suitable drying agent (silica gel).
About the combustion engine model check the "operation and
maintenance" manual of the motor
10 Disposal
10.1

Disposing of the machine

At the end of its working life, the machine must be scrapped and
disposed of by taking it to a local differentiated waste collection
centre in compliance with current legislation which must be followed
scrupulously. Before disposing of the machine, check the machine
rating plate. If it bears the
regulated by EC directive 2002/96 on Waste Electrical and
Electronic Equipment,
information on the local electrical and electronic products collection
system and follow the instructions. Disposing of this product illegally
in the household waste could cause serious damage to the
environment and human health and you may be liable to sanctions
from the local authority.
11 Table of regular maintenance
For the regular maintenance of Combustion engine model check the
"operation and maintenance" manual of the motor.
OPERATION
Check the functioning of all
controls
Check connector gaskets
Check oil level in the pump
symbol, this means its disposal is
WAEE. You should therefore
X
X
X X
12 Troubleshooting
The table below gives the most common problems which may arise
during normal use of the high pressure washer.
These problems are easy to resolve with operations classified as
routine maintenance If the problem is not present in the following
table or cannot be eliminated following the instructions here, contact
customer service.
PROBLEM
The machine
does not start
up
seek
The engine
runs irregularly
Motor does not
start but makes
a noise
Inadequate
pressure
Vibrations
and/or
abnormal water
discharge
Pump noisy
"White" oil
Water leaks
MODEL CAUSE
Combustion Low fuel
engine
Combustion other
engine
Electric Electrical
model power supply
absent or
inadequate
Electric Electrical
model protection
tripped
Combustion Check before
engine each start
Electric Inadequate
model voltage
All Nozzle
blocked or
distorted
All Valve dirty or
worn
All
The pump is
sucking in air
All Air in the
hoses
All Pump
gaskets worn
All Suction
delivery
valves
blocked
All Bearings
worn
All Seepage of
water into the
oil (emulsion)
All
Gaskets
and/or
pistons worn
REMEDY
Fill the fuel
check the
operation and
maintenance
manual of the
motor.
Check the
characteristics of
the power line
Contact
customer service
Contact
customer service
Check the
characteristics of
the power line
Clean or replace
Contact
customer service
Check water
supply
connectors
Vent the air by
disconnecting the
hose
Contact
customer service
Unscrew valve
caps, remove
and clean (ideally
contact customer
service)
Contact
customer service
Have the seal
pack replaced by
customer service
Have the seal
pack replaced by
customer service