TFA MULTI-COLOR Instrucciones De Uso página 13

TFA_No. 60.2548_Anleitung 09.07.2018 11:12 Uhr
MULTI-COLOR – Radio-controlled alarm clock with colour change display and outdoor temperature
3.1.2 Buttons (Fig. 2)
B 1: SNOOZE/LIGHT sensor button
B 3: AL.SET button
B 5: UP button
B 7: AUTO COLOR button
B 9: RIGHT button
3.1.3 Housing (Fig. 2)
C 1: Battery compartment
C 3: USB Port
3.2 Transmitter (Fig. 3)
D 1: Battery compartment
4. Getting started
• For a permanent backlight, to use the charging function and to conserve battery power, use the supplied power adapter.
• Place the base station and the transmitter on a table at a distance of about 1.5 meters from each other. Avoid being close to possible sources of
interference such as electronic devices and radio equipment.
24
Seite 13
B 2: T.SET button
B 4: ALARM ON OFF switch
B 6: DOWN button
B 8: LEFT button
B 10: BACKLIGHT HI LO switch
C 2: Power adapter jack
D 2: Wall mounting hole
MULTI-COLOR – Radio-controlled alarm clock with colour change display and outdoor temperature
• Open the battery compartment of the base station and insert two new AA 1.5V batteries, polarity as illustrated.
• The device will alert you with a beep and all segments will be displayed for a short moment.
• Close the battery compartment again.
• Insert the power adapter pin into the device jack and connect the plug to a wall socket.
• Important! Make sure that your household voltage is no more than 240V! Otherwise your device may be damaged.
• The device is ready for use.
• Open the battery compartment of the transmitter and insert two new AAA 1,5 V batteries. Make sure the polarity is correct. The red LED flashes.
Close the battery compartment again.
4.1 Outdoor values reception
• The base station will scan the outdoor values of the transmitter. The reception symbol flashes. If the reception is successful, the outdoor tempe-
rature appears on the base
• If the reception of the outdoor values fails, "- -" appears on the base station display. Check the batteries and try it again. Check if there is any
source of interference.
• You can also start the outdoor transmitter search manually later on (for example when the outdoor transmitter is lost or the batteries are changed).
• Press and hold the DOWN button for 2 seconds. The reception symbol flashes.
4.2 Radio-controlled time reception
• After the base station has completed the search for the transmitter, the device starts scanning the DCF signal (radio signal) and the DCF reception
symbol flashes.
25