ABC Design Carry Soft Manual De Instrucciones página 7

1. Fitting the side panels
Insert the two side panels in the side openings at the head end. Close the opening with the
Velcro fastening.
WARNING: Do not use the carrycot unless all the zip fasteners are closed.
2. Fitting the carrycot on the pram
a) Recline the back of the seat.
Position the carrycot on the pram.
b) Take hold of the straps which are fitted to the carrycot and feed them around the frame
then fasten the press stud.
c) Take hold of the belt which is attached to the carrycot and place it around the backrest of
the pushchair then fasten the clips.
Pull the belt tight.
WARNING: The CARRY SOFT may only be used as a carrycot if the
reinforcing panels are inserted in the sides of the carrycot.
The side reinforcements should only be taken out if you want to wash the
product.
EN - 04