Parts Diagram; Assembly And Use - Guardian G2-202BX1 Manual De Instrucciones

CAUTIONS
1. Inspect all parts for possible damage before assembling. If there is any
damage - DO NOT USE. Contact dealer/carrier for further instructions.
Allen hex tool and wrench included for assembly.
2. Make sure that each U-Clip extends fully into the same corresponding hole
of each leg extension. This ensures that the leg extensions are securely
locked in place at an even height.
3. Make sure all screws, nuts and/or bolts are tightened.
4. Make sure the rubber tips are in place on the leg extensions and not
ripped, worn or missing. Replace any missing or damaged tips.
5. The rubber tips of all four leg extensions MUST touch the floor
simultaneously at all times.
6. NEVER stand on chair.

PARTS DIAGRAM

ASSEMBLY AND USE

READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THIS CHAIR.
1. Place seat upside down on work surface.
2. Place cross bar B into diagonal seat channel and cross bar A perpendicular
over B in other seat channel. (Figure 1)
3. Use the Allen hex tool to attach the four screws securing the seat to the
frame. (Figure 2)
4. Secure middle screw with washer into the middle position on frame and
seat. (Figure 3)
5. Secure middle screw on frame using Allen hex tool and wrench. (Figure 4)
6. Slide first leg into frame, adjust to height, then insert C-Clip into pre-drilled
holes. Repeat for each leg at same height. (Figure 5)
G2-202BX1 (PIC-00303)
REVISED: 09/29/20