Additional Specific Safety Rules - Delta 46-455 Manual De Instrucciones

ADDITIONAL SPECIFIC SAFETY RULES

. DO NOT OPERATE THIS MACHINE UNTIL it is
assembled installed
OBTAIN ADVICE from your supervisor, instructor,
or another qualified person
FOLLOW ALL WIRING CODES
ROUGH CUT THE WORKPIECE
EXAMINE THE WORKPIECE FOR FLAWS
SECURELY FASTEN THE WORKPIECE
NEVER DRIVE THE WORKPIECE
SNUG THE TAILSTOCK CENTER
PROPERLY ADJUST THE TOOL REST HEIGHT.
ADJUST THE TOOL REST
TIGHTEN ALL CLAMP LOCKING HANDLES
ROTATE THE WORKPIECE BY HAND
CLEAR THE LATHE BED OF ALL OBJECTS
EXAMINE THE SET-UP CAREFULLY
STAND CLEAR, AND KEEP ALL OBSERVERS AND
PASSERSBY
USE THE LOWEST SPEED
NEVER ADJUST THE TOOL REST
NEVER LOOSEN THE TAILSTOCK SPINDLE
MOVE THE CUTTING TOOL INTO THE WORKPIECE
SLOWLY,
REMOVE THE TOOL REST
NEVER PERFORM LAYOUT,
Failure to follow these rules may result in serious personal injury.
to
SAVE THESE INSTRUCTIONS!
TURN THE MACHINE "OFF" AND DISCONNECT
THE MACHINE
TURN THE MACHINE "OFF" ,
THE "OFF" POSITION
TIGHTEN ALL SCREWS AND LEVERS SECURELY
WHEN USING THE INCLUDED 3" (76 MM)
FACEPLATE, DO NOT MOUNT PIECES LARGER
THAN 6" (152 MM) IN DIAMETER
KEEP HANDS OFF WORKPIECE
USE ONLY ACCESSORIES RECOMMENDED FOR
THIS PRODUCT
BE SURE CORD IS NOT IN THE WAY
DO NOT TOUCH THE TIP OF YOUR TURNING
TOOL
DO NOT APPLY WATER OR OTHER COOLANTS TO
LATHE
DO NOT TURN MATERIALS OTHER THAN WOOD
ON THIS LATHE.
BE SURE ANY CHUCK KEYS OR WRENCHES ARE
OUT OF THE CHUCK
FOR THE DELTA ® MODEL 46-460 MIDI-LATHE
ONLY
ADDITIONAL INFORMATION
LOCK THE SWITCH IN