Faceplate - Delta 46-455 Manual De Instrucciones

FACEPLATE

To reduce the risk of injury, tighten all
screws and levers securely when adjusting any part of
the lathe.
To reduce the risk of injury, when using the
included 3" (76 mm) faceplate (B) Fig. 2, do not mount
pieces larger than 6" (152 mm) in diameter and up to 6"
(152 mm) in length. For mounting larger pieces, be sure
to use an appropriately sized faceplate.
REMOVING FACEPLATE
REPLACING FACEPLATE
FOR THE DELTA
LATHE ONLY: To reduce the risk of injury, if turning
in reverse, be sure to tighten the set screws (L) Fig. 2
securely when replacing the faceplate.
Mounting the Workpiece
MACHINE USE
® MODEL 46-460 MIDI-
L
M
Fig. 2
Fig. 3
K
Fig. 4
B
H
I
B