Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. PLACEMENT OF THE BATTERY
From the Call Point software it is possible to create message time schedules and volume time schedules, and send these schedules
to the equipment. In this way, it is not necessary a server PC to activate the time schedules, but it is the computer that activates
them automatically.
To do this, the equipment incorporates an RTC (Real-Time Clock) whose function is to maintain the current time. To keep the RTC
powered even if the equipment is turned off, we must place a 3V lithium battery type CR2032 supplied with the equipment.
It is advisable to replace the equipment battery at least every 5 years.
Handling batteries properly:
•
Warning! Improper use of battery may lead to explosion. Replace the batteries with the same or equivalent type only.
•
Batteries may endanger life if swallowed. If a battery is swallowed, seek medical assistance immediately.
•
Before inserting the batteries, check whether the contacts in the device and batteries are clean and, if necessary, clean
them.
•
Only use new batteries.
•
Do not use rechargeable batteries
•
Never try to recharge normal batteries. There is a risk of explosion!
•
Never expose batteries to heat sources (e.g. radiators) or direct sunlight. There is an increased risk of leakage!
•
Never short-circuit the batteries.
•
Never throw batteries into a fire.
•
Do not disassemble or deform batteries.
•
If the equipment is not going to be used for long periods, remove the battery.
•
Remove leaking batteries from the device immediately. If battery acid leaks out it is essential to avoid contact with the skin,
eyes and mucous membranes! If the acid does come into contact with skin, immediately rinse the affected areas with
plenty of clear water and consult a doctor immediately. There is a risk of acid poisoning and acid burns!
•
Remove exhausted rechargeable battery from the device immediately! There is an increased risk of leakage
•
Do not throw used batteries into the household waste. The batteries must be deposited in a collection point for used
batteries.
Battery placement procedure
1) Disconnect the power supply to the equipment.
2) Unscrew and pull out the battery module.
3) Insert the battery according to the polarity shown in
figure 3.
4) Once it is in place, reinsert the battery module.
IF-7WDCETH version 5.2.001 ENG
IF-7WDCETH
4ETH
Class D wall-mounted amplifier
Figure 3
with IP connection
6
Publicidad
Tabla de contenido
