Declaration Of Conformity - Beta 310/1 Manual De Uso E Instrucciones

EN I
OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
Cleanlng
Before cleaning or carryng out any maintenance jobs, disconnect the polywelder from the supply mains.
Do not use any water for cleaning and/or cooling. The body of the polywelder can be cleaned with a damp cloth.
Focus your attention on the temperature that can be reached by the plate (210°).
Taking the device to pieces • Dividing the materials used
The polywelder is not provided with any dangerous parts, nor does it include any polluting parts:
ALLUMINIUM
STEEL
PLASTIC
ELECTRIC WIRES
THERMOSTAT
General welding standards
Installation
Mount the pair of bushes to be used to the plate of the polywelder by means of the relevant screw. Connect the
device to the supply mains. When the red LED is on, the device is operating. When you turn on the polywelder
for the first time, a small quantity of smoke may come out. The reason is just that some coating residues are
being automatically removed.
Operation
Wait until the green LED turns on for the third time - that is, until the polywelder has reached the
temperature set on the thermostat. Now the welding process can be started. Handle the polywelder
with care, holding it only by the handle.


Declaration of conformity

We hereby state - taking full responsibility - that the device has been manufactured in accordance with the European
EN 60335-1 standard, under the 73/23/EEC directive.
6