Declaration Of Conformity - Beta 1940E10 Manual De Uso E Instrucciones

USE
Start / Stop
To start the air hammer, press the trigger (picture 2-b), and keep it pressed during the job to be performed. Releasing the trigger will
cause the pneumatic tool to stop quickly. Do not idle the air hammer, to avoid damaging the internal piston and the face of the chisel.
Chisel installation/replacement
Install the chisel in the air hammer as follows:
– Pull the bayonet nut of the spindle back, to widen the seat and allow the hexagon drive of the chisel to be fitted in (picture 3-c);
– Fit the chisel in completely, so that the collar can be locked in the bayonet spindle (picture 3-d);
– Check that the chisel has been fixed correctly, and start working.
Replace the chisel as follows:
– Pull the bayonet nut of the spindle back, to widen the seat. Then remove the chisel;
– Fit in the new chisel and follow the above instructions.
Spring retainer use
– To remove the bayonet spindle, loosen the retainer screws and unscrew the spindle (picture 4-e);
– Fit the chisel into the air hammer;
– Screw the spring retainer onto the spindle shaft (picture 5-f);
– Check that the chisel has been fixed correctly, and start working.
Always disconnect the air supply before making any adjustments or fitting in the chisels. This precaution will prevent the air
hammer from being accidentally started.
Lubrication/Greasing
The pneumatic tool must be connected to a filter-lubricator unit (we recommend Beta item 1919F1/4) provided with an air-oil microfog
mixer, set at two drops per minute. This will result in a high-performing tool and wear-resistant mechanical parts.
If lubrication is not provided to the line, oil ISO 32 must be periodically poured into the pneumatic tool, through the air supply hole
(picture 7-g).
MAINTENANCE
Maintenance and repair jobs must be carried out by trained personnel only. For such jobs, you can contact Beta Utensili S.P.A.'s repair
centre.
DISPOSAL
The pneumatic tool, accessories and packaging should be sent to a waste disposal centre, in accordance with the laws in force in your
country.
WARRANTY
This tool is manufactured and tested in accordance with current EU regulations. It is covered by a 12-month warranty for professional
use or a 24-month warranty for nonprofessional use.
We will repair any breakdowns caused by material or manufacturing defects by fixing the defective pieces or replacing them at our
discretion.
Should assistance be required once or several times during the warranty period, the expiry date of this warranty will remain unchanged.
This warranty will not cover defects due to wear, misuse or breakdowns caused by blows and/or falls. In addition, this warranty will no
longer be valid if any changes are made, or if the pneumatic tool is forced or sent to the customer service in pieces.
This warranty explicitly excludes any damage to people and/or things, whether direct or consequential.
We hereby declare, assuming full responsibility, that the described product complies with all the relevant provisions of Machine
Directive 2006/42/EC and amendments thereto, as well as with the following standard:
• EN ISO 11148-4
The Technical Brochure is available at:
BETA UTENSILI S.P.A.
Via A. Volta 18 - 20845 Sovico (MB) - ITALY
Name and title of person in charge
MASSIMO CICERI
(Managing Director)
BETA UTENSILI S.P.A.
Via A. Volta 18
20845 Sovico (MB)
ITALY

DECLARATION OF CONFORMITY

Date 01/01/2015