Positioning - CORBERO CPCGM5F5021 N Manual De Usuario

Positioning

CLEARANCES REQUIRED
WHEN FITTING THE HOB
WITH A COOKER HOOD ABOVE
700mm
400mm
FO 0813
CPCGM5F5021N：560*480mm
This appliance is to be built into a kitchen unit or 600mm worktop,providing
the following minium distances are allowed;
The edges of the hob must be a minimum distance of
o
rear wall.
700 mm between the highest point of the hob surface (including the burners)
o
and the underside of any horizontal surface directly above it.
400 mm between the hob surfaces, providing that the underside of the
o
horizontal surface is in line with the outer edge of the hob. If the underside of
the horizontal surface is lower than 400 mm, then it must be at least 50 mm
away from the outer edges of the hob.
50 mm clearance around the appliance and between the hob surface and any
o
combustible materials.
You must have a gap of at least 25 mm and at most 74 mm between
o
the underneath of the appliance and any surface that is below it.
- An oven must have forced ventilation to install a hob above it.
- Check the dimensions of the oven in the installation manual.
- The cut out size must obey the indication.
CLEARANCES REQUIRED WHEN
FITTING THE HOB WITH A COOKER
700mm
400mm
CPCGM3F3122W：560*480mm
CPCGM3F3121N：560*480mm
CPCGM4F4122W：560*490mm
CPCGM4F4121N：560*490mm
16
HOOD ABOVE
400mm
400mm
60 mm from a side or
45 mm